Patriot Cooling on the road in Southwest Florida
The Patriot Cooling box truck — now hiring technicians
Service van loaded and ready to roll
Installations
New Russell condensing unit installed for a walk-in freezer in Naples
Condensing unit coil side — clean, level install on a raised stand
Dual-fan evaporator inside the walk-in freezer
Finished condensing unit with insulated line set
Insulated refrigeration piping, neat and sealed
Verifying system pressures with digital gauges at startup
Testing the system after installation
Box temperature right where it should be
Control wiring done neat and labeled
Wiring the control panel on a walk-in freezer install
New Russell evaporator mounted inside the walk-in
New evaporator coil delivered and ready to hang
Three-zone control panel wired and live
New air handler going in with a custom plenum
New condenser fan section going into place
Repairs
Running diagnostics with digital gauges
Rooftop package unit opened up for repair
Fan motor out for replacement on a Rheem condenser
New capacitor in hand — most no-cool calls end right here
Chasing an electrical fault inside an inverter unit
Opening up a condenser to find the problem
Blower inspection — the Patriot service sticker tells the system's story
Evaporator coil exposed for diagnosis
The controls flagged a suction temp sensor fault — found it
New filter drier going in
Filter drier installed and clamped on the liquid line
Recovering refrigerant the right way, weighed on the scale
New fan motor going in after dark — that's the 24/7 part
Drain line clearing in progress
This is what was living in that drain line
Maintenance
Coil cleaning day — foam pulling the dirt out
Foaming the condenser coil during a tune-up
Found the airflow problem — this filter was overdue
Deep-cleaning a mini split fan housing
Mini split coil getting the foam treatment
Final rinse on a wall-mounted mini split
Ceiling cassette filter pulled for cleaning
More of Our Work
